Monday, December 10, 2012

The sales group of this laser pointer company is very strong

The sales group of this laser pointer company is very strong and powerful.
The use of robots, the wrench of the clamp grasping device must be large enough in order to seize a large workpiece clamp grasping device must be equipped with smart sensors (sensory and visual), the height used to detect stack components. The solution is the use of epoxy carbon fiber to make the clamp grasping device, with many small suction cups and miniature inductive sensors. In order to be able to draw multi-block processing board, the use of a slight tilting movement of the cylinder is applied to the clamp grasping device. Laser flexible manufacturing system, ASR (effective supply rate) warehouses to store the processing board. More than one level of ASR warehouse at the same time for 1-3 machining centers, machine tools without having to install their own pallet. This type of laser pointer will bring the great profit to the laser pointer company.
The manufacturer should indicate the level of the laser radiation may be close to, and recommendations on each case (if appropriate) security program. Training, planning and program verification during the period of protection. Should be avoided during validation of the training, planning and program personnel close to the laser radiation above the Class 3A AEL. If you can not satisfy this condition, you should meet the protection requirements of the maintenance period. Control devices and control circuits should comply with the requirements of GB / T 5226.1. The laser processing machine shutdown switch should enable the processing machine downtime (actuators power), or isolate the laser beam or laser beam is no longer generated. Laser stop switch should enable the laser beam is no longer generated. Laser system and the rest of the processing machine, you can use a separate control device. The defect of laser pointer can be easily eliminated.
Emergency termination of the switch should be consistent with the requirements of GB / T 5226.1. Emergency termination of the switch should be able to at the same time: the laser beam is no longer generate the laser shutter and automatically put in place; processing machine downtime (actuators power); cut off the laser power and the release of stored energy. If several processing machines share a single laser and machining work independently of each other independent of the installation in a machining emergency termination of the switch should work as something like the above requirements, or the processing machine downtime (actuators off electricity), while cutting off the laser beam leading to the processing machine.

No comments:

Post a Comment