It with the standard and procedure of laser pointer strictly obeyed

It with the standard and procedure of laser pointer strictly obeyed.
And treatment decisions, and caries of pit and fissure at the surface with a fine emery drill open the head with a small optical fiber in-depth gap of Er: YAG laser to remove carious induced fluorescence in the red light to reach the defect after the equipment here carious tissue fluorescence was recorded fluorescence as a feedback, where caries is selective removal of the case is not visible to the naked eye, especially fiber issued by the lateral light through the keyhole surgical way, will further remove the side of caries in this way, caries will be removed completely healthy tooth enamel protection, natural tooth occlusal surface structure can be preserved. The manufacturer should carry out the quality control following the specific steps of laser pointer .Laser printers alive paper rules scratches. Analysis: When the printer pattern black stripes or vertical blur the toner in the paper.
Red, green, blue laser is a color display of RGB light source, compared with the fluorescent light source, a higher beam quality and efficiency, there is no fluorescent light sources produce green shadow and incandescent light yellow shadow, you can achieve the balance of the three primary colors. The laser display industry chain is very broad, including semiconductors, artificial crystal, optical cold, graphics engine, digital signal processing, the whole integration of technology. Specifically, the industrial chain of the compound semiconductor and packaging, laser pump source, intraocular lens, laser laser industry, which is upstream of laser display industry. Integrating technology and optical engine technology used in the display field of lasers and laser light source, light machines. This laser power is needed is a method to what is the traditional method in the same material removal rate, in addition to the small amount of micro-crack. Drawn, psychological specimens of alumina ceramics, and laser CO2 laser source and Nd - YAG laser. This fracture processing technology to the electromagnetic-ployed on the step shape and blind bend forming thick ceramic substrate. Processing relationship Groove-crack depth parameters, data-moval rate, the laser scanning speed, laser power discussed. Finally, the surface of the surface roughness measurement and inspection of the cracks.
But the melting point is too low, the stability of the toner will become poor. Test, we can hand touching the surface of the print graphics, to feel its rough, you can determine its fixed good and bad. In general, the text given with less toner to print the surface is very rough.