laser pointer is extremely good in brightness

laser pointer is extremely good in brightness.
Camera film box set off the machine back cover open, remove the four screws of the exposure box to be removed from the back to open the laser head will wipe clean the mirror with a clean cotton swab dampened with water (be careful not to change each The original state of the lens), the reverse will restore the machine connected to the computer and camera, the automatic adjustment of the laser power in the connected machine software, power test, the machine returned to normal. Example 3: Kodak 8100 failure phenomena and processing: POST error Tip: Pl19 lights. Open the front door front door off switch with a screwdriver stuck in the dim light under observation during POST and found that the film box does not open, remove the film boxes observation, see a film glued to the edge of the film box.  laser pointer is clearly visible in the dark night.
 Film output of the heating drum surface temperature up to 120 ℃ or more, the base film with easy adhesion to the above, resulting in film contamination or card should be regular cleaning of the heating drum, general printing would need to be cleaned once in the film about ten thousand; transfer roller long run will cause pollution or location move, should normally be six months cleaning and calibration time. Dry laser film imaging by thermal printing, ambient temperature and preservation of film preservation time a great relationship, the ambient temperature within 5 ~ 25 ℃ can be stored for more than 3O years, if the temperature is over 3512 will be greatly shortened to save time. The causes and treatment cards on the card is the most common faults in the use of KODAK Dry view dry-type laser camera. After the long time development of the green laser technology of laser pointer .
Occur in any stage of the film transfer process. Comprehensive analysis of the card causes the following aspects: sucker bad or suction caused by the uneven card; transfer roller uneven pressure or to move into the film, the deflection caused by the card, roller prolonged use of film membrane or foreign body in pollution shaft friction increases can also result in the card; heating temperature is too high or film to save space temperature is too high lead to the base membrane adhesion to cause the card on the transfer roller drum; sensor failure or a sudden power failure, resulting in the transfer piece interrupt causing Card. If the card, orange lantern light in dry laser camera on the front panel LCD screen will prompt failure. So the green laser pointer is widely used in many occasions.Open the camera back. Manual door control switch is closed. Visible seizure arm seizure action, the film can reach the film feed shaft.