The customer wants to visit the production process of Laser Pointer

 The customer wants to visit the production process of Laser Pointer .
To this end, electrical equipment should be placed in sealed cover within or absorption method to get rid of these gases or vapors. If the laser equipment or facilities operating voltage is higher than the voltage specified in Table 1, in addition to the provisions of the standard 3.4 region, should prevent foreign objects greater than 1mm in diameter into the shell. Prevent the use of tools, wires or other objects larger than 1mm thick and chassis contact with live or moving parts. Article 5.12.3 of this standard through the test examination. It is not convenient to arrange the customer to visit the production process of Laser Pointer .
When the case of vertical tilt to 15 ° when the droplets fall should be no harmful effects. Article 5.2.3 of this standard by the provisions of Article 5.3, 5.4 and checked by the test. Vertical surface of the aluminum into a 60 ° or 60 ° less than the fall of rain should be no harmful effect. Through 5.2.4 and 5.3 of this standard and 5.4 under the test examination. In either direction of the sputtering of liquid should be no harmful effect. By this standard 5.2.5 and 5.3 and 5.4 of the tests specified to be checked. The conditions provided for in any direction from the nozzle spray out of the water should be no harmful effect. By this standard 5.2.6 and 5.3 and 5.4 under the test to be checked. The production process of Laser Pointer is confidential.
Cable to be used at least 2 times the rated working voltage of the test voltage to choose. This is not suitable for transfer trigger pulse voltage cables, which should be based on Article 5.7 of the standard test for selection. If the cable has a protective braid, then braid to protect the machinery to be solid and reliable, and easy to ensure contact with the electrical components with well-connected. If the braid also offering protection circuit loop must also comply with the standard 5.12.1.1 of the requirements, inspection and protection braid connection is disconnected. Maintenance, attention should be the minimum bend radius of the laser pulse, transmitted pulse current of the cable should comply with the standard 5.7 test requirements. The manufacture process of Laser Pointer is not open to the non-employee. The production process of Laser Pointer should be managed well.
Acne plugs and plug should be no risk of direct contact, even in the process pull the plug, pull the plug or disconnect contact elements within 2s after contact with live parts shall comply with the requirements of Article 4.3.2 of this standard. And should prevent the voltage exceeding 1kV plug disconnected for no reason. Cable should be free from tension, stress, and shear resistance. Must eliminate the pull mode of operation and anti-torque device.