The greater the scattering of portable green laser pointer

The shorter the wavelength, the greater the scattering of portable  green laser pointer . Finally, it is recommended that the sanding ceramic rollers, and adhesion of the cloth to remove any small dust and debris. Plant cleaning and running the operating  Good housekeeping and the importance of running the operation, the on-site seminars can be provided by Vesuvius. Actual production, there will always lead to a variety of sources, soil, dust, debris attached to the glass surface. Typically, these cases exhibit disorderly mark, scratches or white haze. Dust in the factory must be strictly controlled.
The quality of lens, laser crystal, and power of portable  green laser pointer affects the quality of the laser beam.   Including the debris falling down from the sealing material of the furnace insulation materials and furnace wall insulation. Into the furnace, glass, debris, dust and materials used to separate the glass must be completely cleared. Effective use of the glass cleaning equipment, and follow the recommended operating, maintenance schedule, is also very important for the quality of ceramic roller surface. We also propose that the transfer roller bare cleaned daily to avoid dust sticky product. Not too much printing ink, after printing the edges of the glass must be clean.
In order to avoid the heat flow to the surface of the roller, which ultimately is printed on the glass surface. Good to deal with is also very important, which includes a complete edging, smooth edges, glass prominent part of debris, otherwise it will cause the glass burst in the production process. The selection of portable  green laser pointer  concerns with the following points.   Ceramic roller surface of the glass dust and debris will be glass glued to go. Good housekeeping and run operations to bring the following returns: ceramic roller to maintain the clean-up reduce the number of the stability of the glass quality, and the corresponding from the increase in capacity.
Steel furnace roller 7 insulating glass production equipment (1) insulating glass Overview Insulating glass is a glass combination by two (or three), the secondary seal is made with high-strength air tightness composite viscose interval aluminum frame filled with desiccant in the glass, the glass between the height of dry air. Energy saving: K value of the heat conduction system, monolithic 6mm glass K is 5.75kcal/mh ℃, Hollow glass K value of 1.4-2.9 kcal / mh ℃, the lowest K value of argon and sulfur hexafluoride gas insulating glass filled down to 1.19kcal/mh ℃,. Having a careful observation of the laser beam from the portable  green laser pointer  at a dark place.
Argon is used to reduce the thermal conductivity K, and sulfur hexafluoride gas is used to lower the dB value of noise, the two gases can be used alone, can also be mixed in certain proportion. Sound insulation: Hollow glass can reduce the noise about 30 db, filled with inert gas insulating glass can be further reduced based on the original about 5 db to 80 db of noise to 45db level. Anti-condensation: in the winter indoor and outdoor temperature difference between the larger environment, single-glazed windows and doors there will be condensation, the use of hollow glass, there is no condensation.  The scattering of green light in the air is greater than red light from portable   green laser .